Home > Air Tanks >

5 Gallon Slim & Skinny 7 Port "Black" Steel Tank, DOT Approved-sold each
Slim & Skinny 5 gallon tank


 
Alternative Views:


List Price: $105.47
Our Price: $75.45
Savings: $30.02

Availability:: Available
Product Code: HT-70XX-21
Qty:

Description
 

5 Gallon Slim & Skinny Tank, Same as Firestone 9248 P/N but with 3/8" NPT Ports.


Brand New 5 Gallon slim & skinny "Black color" DOT APPROVED steel tank with 6 3/8" NPT & one 1/4" NPT port at bottom. Sold each. Proudly Made in USA. Not a cheap knock off, made with high quality in USA.

This Tank is same as Firestone P/N 9248 but this one has 6 3/8" NPT ports with one 1/4" NPT Port at bottom. Firestone tank comes with 6 1/2" NPT & One 1/4" NPT at bottom. Suitable for any air ride suspensions as well as train horn or load support applications. You can use 1/4", 3/8" OR 1/2" NPT valves with this tank. Most suitable for any Viair single or dual compressors with 1/4" OR 3/8" NPT leader hoses.

Painted inside with water based "cortec" to prevent rust and black semi gloss epoxy on outside.

ALL PORTS ARE NPT. NPT Ports measure bigger when measured with tape then what actually they are.

Features:

  • Made in USA. DOT Approved.
  • Slim & skinny design with ports to use with 3/8" NPT or 1/4" NPT compressor leader hoses.
  • Can be used with 1/4" NPT, 3/8" NPT OR 1/2" NPT Valves. For basic front & back setup (4 valves) OR Full FBSS (8 Valve) setup.
  • Slim & skinny design is perfect for under vehicle or in bed or inside trunk mount applications.
  • Tank measures 32.81" end to end & 34" inches from side bung to bung. Tank dimensions 34" L X 7" D X 9.25" H.
  • Painted inside with "Cortec" water based coating to prevent rust. Outside paint "Black Epoxy". semi- gloss type.
  • Suitable for any Train Horn, Air ride suspension or load support applications.
  • Compatible with any of the Viair compressors with 3/8" OR 1/4" NPT leader hoses.

Specifications:

  • 34" L X 7" D X 9.25" H with mounting holes at 21.75" apart center to center.
  • 2 3/8" ports one on each end, 4 3/8" NPT ports on face & one 1/4" NPT port at bottom for drain.
  • Tested at 150 PSI max with burst pressure of 400 to 450 PSI. Safe for 200 PSI pressure applications.
  • Welded seam offset from bottom center to relieve stresses due to welded ends.
  • Painted inside "Cortec" water based coating to prevent rust & "Black semi gloss" Epoxy on outside.

Share your knowledge of this product. Be the first to write a review »